hasmenu.blogg.se - Lexia 3 diagnostic tool with diagbox and pp2000

#LEXIA 3 DIAGNOSTIC TOOL WITH DIAGBOX AND PP2000 HOW TO#
#LEXIA 3 DIAGNOSTIC TOOL WITH DIAGBOX AND PP2000 CODE#

Throttle Switch Unit (Full Load Position). The “CHECK ENGINE” indicator should be “ON” and all fault codes should have been cleared. Depress the switched jumper for more than 10 seconds.

#LEXIA 3 DIAGNOSTIC TOOL WITH DIAGBOX AND PP2000 CODE#

Perform a test sequence up to a code 11.To erase the fault code memory turn the ignition switch to the “RUN” (ON) position.Disconnecting components and wiring harness connectors with the ignition switch in the “RUN” (ON) position may set additional codes and cause permanent damage to the Motronic system. Be sure to disconnect the “switched jumper” and turn the ignition switch to the “OFF” position before attempting repairs.

Repair the indicated faults or repeat the test.

Code 11 signals the end of the test sequence and there are no other codes stored. Refer to the fault code chart. Up to 5 codes may be stored in the fault memory.

Repeat steps 4 and 5 until a code 11 is displayed.

The combination of the (tens)+(units) is the displayed fault code. Take note of all the stored codes. Remember the first set of flash codes is the (tens) and the second set of flash codes is the (units).

Wait for the “CHECK ENGINE” light to come on continuously.

Thus, a code 12 which indicates the beginning of the “TEST” sequence has been displayed. Open the “switched jumper” and the “CHECK ENGINE” indicator will:

Close the switched jumper for 3 seconds. The “CHECK ENGINE”.

Turn the ignition switch to the “RUN” (ON) position.

Connect the other terminal of the switched jumper to a good ground source.

Connect a switched jumper to wire 17 of connector M720 which is the green 2 pin connector.

There is no communication between lexia 3 device and computer. It has original 921815C chips inside, and it is also fully compatible with Peugeot 307/C5.

#LEXIA 3 DIAGNOSTIC TOOL WITH DIAGBOX AND PP2000 HOW TO#

Here is the instruction on how to do Peugeot codes reading with Lexia-3 PP2000. Lexia 3 with Diagbox V7.57 (item SP08-C) is the best lexia diagnose tool among all the lexia 3 we sell on the shop.